*Contains: 50ml

85mm - 750gr

Once the payment has been completed

The Arduino software includes a Wire library to simplify use of the TWI bus

Easy Installation: Designed for easy replacement and installation on Creality 3D printers

TPM - Wash Solvent - 10L Creality - Reservedel *Contains: 50mlWash Solvent TPM Wash Solvent (Tripropylene glycol monomethyl ether) is a non flammable, low odor solvent that can be used to clean and dissolve uncured resin on SLA DLP 3D printed parts. TPM has a lower evaporation rate than IPA and washes about three times as many parts as IPA before it needs to be replaced. * Compatible with Formlabs Finish Kit, Form Wash and Form Cure * 10 litres ! ATTENTION ! TPM is not currently certified for use with Formlabs