Use with your workshop press to make easy work of removing wheel bearings

Permanent visible ID markings allows for quick tool identification

without control unit for dynamic bending light (AFS)/with bulb - with motor for headlamp levelling/without glow discharge lamp/without ballast

for left-hand traffic - Registration Type: ECE - Country Specific Design: Europe - paired article number: 1LL 009 925-541

5A Max Current

LAZER LAMPS Y-Splitter – Single-Lamp to Two-Lamp (2-Pin, Superseal) Punches And Chisels Use with your workshop pressThe Y Splitter complete with 2 pin superseal connections, is the ideal solution for wiring multiple low power Lazer Lamps avoiding the need for additional wiring kits run in parallel. The splitter is an ideal solution for wiring 3 or more lights, where the power rating of each light is 75W or less, and a corresponding 4 Lamp Wiring Kit doesnt already exist for example. All Lazer lamps are sold with a pre wired female connector attached to the male